汽轮机发电机安装程序.docxVIP

汽轮发电机安装过程简要描述General description of the site assembly of the Steam turbine and generator 汽轮机：Turbine汽轮机运转平台基础浇灌前预埋件检查，重点检查预埋件的标高、垂直度、布置，检查预埋套管自带螺母的螺纹，在预埋套管顶部加装保护罩，安装水平测量点，使用钢板保护，土建开始基础浇灌。Inspection of the turbine foundation embedded parts before concrete pouring, especially on the arrangement ,elevation, inclination and the screw thread, etc. Protect the top of the sleeves with covers before pouring.Arrange foundation leveling points ,covering with protect plate.基础浇灌完成后，对基础进行约一个半月的养护。Concrete pouring and preservation (normally 1 to 1 and half month depending on the temperature)基础养护完毕后，再一次检查浇灌完成后预埋件的标高、垂直度、布置等，土建划出基础上各基准线，基础移交。Inspection again after foundation preservation on the embedded parts; Draw the baseline on the foundation and hand over from civil works to the STG erection. 基础凿毛，去除基础表面浮浆露出鹅暖石。按照锚固件布置图，对锚固件象脚进行布置，根据扬度曲线调整象脚标高，检查象脚的标高，水平、布置。On the area of placing foundation parts, chipping the foundation to remove the outer skin of the concrete; According to the STG arrangement drawing and shaft line alignment diagram, place the “elephant feet” and adjust the leveling; inspection and record of the arrangement and the leveling.制作锚固件模具，预埋套管顶部做好保护，使用SIKADUR对锚固件进行浇灌。Build the frame around the “elephant feet” and fix them; Protect the top of the sleeve with covers and grout with synthetic resin mortar (SIKADUR) to fix the “elephant feet” on the foundation.待SIKADUR凝固达到额定强度后，安装轴承座。When the hardness of the SIKADUR reaches the requirement valve, start placing bearing pedestals.沿汽轮发电机组轴线拉钢丝线，纵向布置各轴承座，模拟转子轴线纵向拉钢丝，对照钢丝调整各轴承座，并紧固轴承座地脚螺栓。Install violin wire in the axial center line of the steam turbine and generator; place all bearing pedestals on the elephant feet, align them to the violin wire and fix the anchorage bolts.安装轴承座底键，点焊底键，拆除所有轴承座，按要求对底键进行焊接，焊接过程中加强监视，检查底键焊接。Install the foundation keys of the bearing pedestals, tack weld; remove all pedestals again and final weld the keys to the foundation (inspection during welding).底键焊接完成后，再次安装轴承座，拉钢丝调整轴承座，并紧固轴承座地脚螺栓。Inst