IMPORTANT NOTICE FOR THE INSTALLER - （安装程序的重要通知）.pdf

ENGLISH ENGLISH IMPORTANT NOTICE FOR THE INSTALLER GENERAL SAFETY INSTRUCTIONS 1) WARNING! For reasons of safety, all the instructions in this manual must be observed scrupulously. Improper installation or misuse of the product may result in serious injury. 2) Read the instructions carefully before installing the product. 3) Packaging material (plastic, polystyrene etc.) is a potential hazard and must be kept out of reach of children. 4) Keep these instructions for future reference. 5) This product has been designed and manufactured only for the use stated in this manual. Any use other than that expressly indicated may result in damage to the product and/or risk of injury. 6) FAAC S.p.A. shall not be liable for any damage or injury caused by improper use of the automation or by any use other than that for which it is intended. 7) Do not install this device in explosive atmospheres: the presence of flammable gas or fumes is a serious hazard. 8) Mechanical structural elements must comply with UNI8612, CEN pr EN 12604 and CEN pr EN 12605 standards. For countries outside the EC, mechanical structural must comply with the above standards in addition to any national safety standards, in order to obtain a reasonable degree of safety. 9) FAAC cannot be held responsible for failure to observe technical standards in the construction of the gates on which the automation is installed, or for any deformation of the gates which may occur during use. 10) Installation must comply with UNI8612, CEN pr EN 12453 and CEN pr EN 12635. The degree of safety of the automation must be C+D. 11) Before carrying out any operations on the system, disconnect the electrical power supply. 12) Install a multi-p