LYCOMING OPERATOR’S MANUAL SECTION 5 （莱康明操作员手册第五节）.pdfVIP

LYCOMING OPERATOR’S MANUAL SECTION 5 MAINTENANCE PROCEDURES Page General 5-1 Ignition and Electrical System Ignition Harness and Wire Replacement 5-1 Timing Magneto to Engine Single Magneto 5-1 Dual Magneto 5-1 Generator or Alternator Output 5-4 Fuel System Repair of Fuel Leaks 5-4 Carburetor or Fuel Injector Inlet Screen Assembly 5-4 Fuel Grades and Limitations 5-4 Air Intake Ducts and Filter 5-4 Idle Speed and Mixture Adjustment 5-4 Lubrication System Oil Grades and Limitations 5-4 Oil Suction and Oil Pressure Screens 5-5 Oil Pressure Relief Valve 5-5 Cylinders 5-5 Generator or Alternator Drive Belt Tension 5-9 Turbocharger Controls 5-9 This Page Intentionally Left Blank LYCOMING OPERATOR’S MANUAL SECTION 5 O-360 AND ASSOCIATED MODELS MAINTENANCE PROCEDURES SECTION 5 MAINTENANCE PROCEDURES The procedures described in this section are provided to guide and instruct personnel in performing such maintenance operations that may be required in conjunction with the periodic inspections listed in the preceding section. No attempt is made to include repair and replacement operations that will be found in the applicable Lycoming Overhaul Manual. 1. IGNITION AND ELECTRICAL SYSTEM. a. Ignition Harness and Wire Replacement – In the event that an ignition harness or an individual lead is to be replaced, consult the wiring diagram to be