MECHANICAL SEAL INSTALLATION INSTRUCTIONS（机械密封安装说明）.pdfVIP

File: I-3577-A.doc Date: 10/23/2008 2:19:00 PM Page 1 of 2 MECHANICAL SEAL INSTALLATION INSTRUCTIONS INSTALLING A MECHANICAL SEAL IN A CENTRIFUGAL PUMP CAUTION: Never put hands on lapped seal faces or put lapped seal parts face down on the workbench. Keep the mechanical seal in its original container until ready for installation. PREPARE PUMP 1. Clean and inspect pump parts. 2. Replace shaft or shaft sleeve and gland if worn in secondary sealing areas under o-rings, Teflon wedges or Teflon rings. 3. Check for good starting bevel and remove all burrs that would cut secondary seal o-rings or cause misalignment. Pay close attention to set screw marks. 4. Check shaft run out (to be within .001” TIR per inch of shaft dia.), shaft end play (not to exceed .005”), stuffing box face alignment (must be square to within .003” TIR and have a good sealing surface, 125 RMS min.) and condition of bearings. Replace if necessary. INSTALLING SEAL 1) Bolt stuffing box back plate to the pump frame. 2) Install shaft sleeve. 3) Screw on impeller to hold shaft sleeve in proper position securely on shaft. 4) Scribe a line on the shaft sleeve at the face of the stuffing box. 5) Remove stuffing box plate. 6) Determine the operating length of a mechanical seal: a) Plac