OPERATING INSTRUCTIONS Uniweld Products（操作指令Uniweld产品）.pdfVIP

OPERATING INSTRUCTIONS regulators [all models] WARNING! READ CAREFULLY AND COMPLETELY BEFORE USING EQUIPMENT. KEEP FOR REFERENCE. NOTICE: throughout this publication, “Dangers“, “Warning” and “Cautions” are used to alert the Technician to special instructions concerning a particular service or operation that may be hazardous if performed incorrectly or carelessly. Observe them carefully! These “Safety Alerts” alone cannot eliminate the hazards that they signal. Strict compliance to these special instructions when performing the service, plus common sense operation, are major accident prevention measures. OSHA 29 CFR 1910.252 D xii and xiv A states, “Management shall recognize its responsibility for the safe usage of cutting and welding equipment on its property and the supervisor shall be responsible for the safe handling of the cutting or welding equipment and the safe use of the cutting or welding process.” DEFINITIONSDEFINITIONS DANGER: Immediate hazards which CAN result in severe injuries or death, damages and losses. WARNING: Hazards or unsafe practices which COULD result in severe injuries or death, damages and losses. CAUTION: Hazards or unsafe practices which COULD result in injuries, property damage and losses. WARNING: We could not possibly know of and advise the service trade of all conceivable procedures by which a service might be performed and of the possible hazards and/or results of each method. We have not undertaken any such wide evaluation. Therefore, anyone who uses a service procedure and/or tool, which is not recommended by the manufacturer, rst must completely satisfy themselves that neither they, the products safety, nor the area in which the work is being performed, will be endang