Optimus Lower Completion Guide, manual mill（擎天柱低完成向导,手工磨）.pdfVIP

AR-15 Lower Receiver Completion Guide Manual Mill Please carefully read these instructions in entirety before beginning. Overview: These instructions are meant to give you some direction in completing your Optimus Defense 80% Lower Receiver. To complete the lower you will be drilling three holes and machining two pockets. To keep the lower receiver within tolerance, pay close attention to the tolerances as you machine. We offer recommended speeds, depths of cuts, and stick out lengths on the final page of this manual. This guide will cover manually machining your lower. It is possible to use drill jigs or a CNC machine if you so choose. Cutters: These tools are included in the Optimus Defense tool kit available for purchase:  7/16” Endmill with a 3/8” shank  5/16” Endmill with a 3/8” shank  3/8” Stub split tip drill bit  5/32” Stub split tip drill bit  1/4” Precision ground rod for part zero Other Tools:  Mill with Vise (needs to be squared)  Edge Finder or suitable touch off method Figure 1  Safety Glasses  Cutting Fluid (recommended but not required) such as A-9 or Tap Magic Aluminum  Dykem (blue dye) or dark color Sharpie  Manual Mill Drawings and Inspection Drawings (available at /documents) Procedure: Hammer and Trigger pin holes 1. Clamp the lower in the vise with the Lower’s left side facing up. Note: Place the lower on parallels or a sacrificial parallel block to avoid drilling the vise. 2. Zero X and Y; Place the 1/4” precision rod in a tool holder and center the rod over the take down hole. Adjust the table until the rod drops smoothly and easily into the take down pin hole. See Figure 2.