Pipe Cladding (Basic) Fabrication Application（管道覆盖层(基本)制造和应用程序）.pdfVIP

TRADE OF Industrial Insulation PHASE 2 Module 1 Sheet Metal and Insulation Fundamentals UNIT: 8 Pipe Cladding (Basic) Fabrication Application Produced by In cooperation with subject matter expert: Michael Kelly © SOLAS 2014 Module 1– Unit 8 Pipe Cladding (Basic) Fabrication Application Table of Contents Introduction 1  Unit Objective 2  1.0  Sketching and Measuring 3  1.1  Sketching Equipment 3  1.2  Sketching a Job 3  1.3  Recording Measurements 4  2.0  Developing a Straight Pipe Section 5  2.1  Positioning of a Joint Line 5  2.2  Parallel Line Development 6  2.3  Mechanical Drawings 7  3.0  Installation and Disassembly of a Cladding Pipe Section 8  3.1  Installation of Pipe Cladding 8  3.2  Disassembly of Pipe Cladding 9  Summary 10  Industrial Insulation Phase 2 Revision 2.0, August 2014 Module 1– Unit 8 Pipe Cladding (Basic) Fabrication Application Introduction The fabrication and application of cladding pipes and fittings requires a high level of skill and knowledge of pattern development, metal forming and the ability to solve problems. Every job will differ in some shape or form and the industrial insulator must be able to meet the challenges of each project, and deliver a top quality job every time. Module 1 Sheet Metal Insulation