网教毕业设计例文.docVIP

西南科技大学网络教育 毕业设计 题目名称： 基于RAM9的直流电机控制系统设计 年 级： 2011秋季 层次： 本科 专科 学生学号： 127160310002 指导教师： 苟 建 峰 学生姓名： 罗 静 技术职称： 讲 师 学生专业： 机电一体化 学习中心名称： 德阳学习中心 西南科技大学网络教育学院制 【摘 要】???连续铸造是一种先进的铸造方法，其原理是将熔融的金属，不断浇入一种叫做结晶器的特殊金属型中，凝固（结壳）了的铸件，连续不断地从结晶器的另一端拉出，它可获得任意长或特定的长度的铸件。连续铸造在国内外已被广泛采用，例如连续铸锭（钢或有色金属锭），连续铸管等。连续铸造和普遍铸造法比较有下述优点：1.由于金属被迅速冷却，结晶致密，组织均匀，机械性能较好；2.连续铸造时，铸件上没有浇注系统的冒口，故连续铸锭在轧制时不用切头去尾，节约了金属，提高了收得率；3.简化了工序，免除造型及其它工序，因而减轻了劳动强度；所需生产面积也大为减少；4.连续铸造生产易于实现机械化和自动化，铸锭时还能实现连铸连轧，大大提高了生产效率。?连续铸造连续铸锭As the development of society and the advance in people’s living standard, More and more vehicles drive on road, meanwhile, road facilities corresponding haven’t got improved, which leads to the prominent of traffic jam. What’s more, traffic jams appear mainly at the gathering area of vehicles such as crossroad. How to improve the current traffic system becomes a hot point to research, and the paper revealed it deeply. Traffic light control system is mainly used to process passing of vehicles and pedestrians, reducing interference between vehicles and to promote the traffic capacity. The paper summarized the development of traffic light control technology and discussed the feasibility of crossroad traffic signal light control system based on PLC. According to the PLC work principle and practical situation of crossroad, the paper presents FX2N-128MT-001 of Mitsubishi Corporation as control core, making arrangements of red, yellow, green light for straight going and for left-face; red， green light on sidewalk and figure manifestation of count down. Completed I/O port-settings and control procedure of PLC. The paper also searched the project of crossroad traffic signal light based on infrared remote control and designed the specific hardware circuit and software control programs. 【Keywords】crossroad; traffic light; PLC; Mitsubishi Corporation; remote controller 目 录 切割部分设计 1.1设计要求 ……………………………………………………………………… 6 1.2方案设计