AWWA STANDARD FOR - ade-v.com（美国自来水厂协会(AWWA标准u2014u2014ade-v.com）.pdf

AWWA STANDARD FOR STEEL PIPE FLANGES FOR WATERWORKS SERVICE-SIZES 4 IN. THROUGH 144IN. (100MMTHROUGH 3,600 MM) Effective date:April 1, 2002. First edition approved by AWWA Board of Directors June 17, 1955. Thisedition approved June 17,2001. Approved by American National Standards Institute Jan. 18,2002. AMERICAN WATER WORKS ASSOCIATION 6666 West Quincy Avenue, Denver, Colorado 80235 A W A Standard This document is an American Water Works Association (AWWA)standard. It is not a specification. AWWA standards describe minimum requirements and do not contain all of the engineering and administrative information normally contained in specifications. The AWWA standards usually contain options that must be evaluated by the user of the standard. Until each optional feature is specified by the user, the product or service is not fully defined. A W A publication of a standard does not constitute endorsement of any product or product type, nor does AWWA test, certify, or approve any product. The use of AWWA standards is enti.rely voluntary. AWWA standards are intended to represent a consensus of the water supply industry that the product described will provide satisfactory service. When AWWA revises or withdraws this standard, an official notice of action will be placed on the first page of the classified advertising section of Journal AWWA. The action becomes effective on the first day of the month following the month of Journal AWWA publication of the official notice. American National Standard An American National Standard implies a consensus of those substantially concernedwith its scope and provi