D. C. Machines Guru Tegh Bahadur Institute of （d . c .机器大师科技阁下研究所）.pdfVIP

D. C. Machines PART 1 Multiple Choice Question 1. In Flemings right-hand rule, the thumb point towards (a) direction of flux (b) direction of induced e.m.f. (c)direction of motion of conductor, if fore finger points along the lines of flux (d) direction of motion of the conductor if fore finger point in the direction of generated e.m.f. 2. The resistance of armature winding depends on (a) number of conductors (b) number of poles. (c) cross-sectional area of die conductor. (d) all of above. 3. The output voltage of a simple d.c. generator is (a) a.c. square wave. (b) a.c. sinusoidal wave (c) pure d.c, (d) pulsating d.c. 4. When tow generators are running in parallel and field of one of them is weakened too much then it will (a) deliver large share of the total load (b) deliver small share of the total load (c) run in the opposite direction (d) run as a motor in the same direction 5. If a shunt generator fails to build up any voltage at no- load, the reason may be that. (a) there is no residual magnetism . (b) field coil may be connected in reverse direction (c) field resistance is more than the critical resistance (d) all or anyone of the above. 6. In shunt generator interpole winding carries . (a) armature current (b) shunt field current (c) full load current (d) none of these 7. Due to which of the following reasons a separately excited generator as compared to a self-excited generator is better? (a) is more stable (b ) has exciting current in dependent of load current (c) is amenable to better voltage (d) has all above features. 8. Due to which of the following reasons, copper brushes in D.C. machine are used? (a) when high voltage and small currents are invo1ed (b) when low voltage and high currents are involved (