ril的基本知识（Basic knowledge of RIL）.docVIP

ril的基本知识（Basic knowledge of RIL） This article assumes that the reader has already understood the basics of RIL From the top layer, add the upper level function in the frameworks/base/telephony/java/com/android/internal/telephony/Phone.java that sends the AT command. Phone is an interface, therefore, add after the realization of this method in the implementation of the Phone interface inside the Java class, Phone class GSMPhone.java in frameworks/base/telephony/java/com/android/internal/telephony/gsm/GSMPhone.java Here, call the method inside CommandInterface, so we have to add the method we want to add in CommandInterface Similarly, CommandInterface is also an interface, and there are 2 classes to implement this interface: 1. frameworks/base/telephony/java/com/android/internal/telephony/gsm/RIL.java 2. frameworks/base/telephony/java/com/android/internal/telephony/test/SimulatedCommands.java Second of them are tested in the simulator, and we just add the method inside, and then call a resultSuccess or umimplement. The first is the class that really reaches the GSM driver. So we have to implement the communication between the upper and lower layers in RIL.java. In the RIL.java method, you only need to define a that you need to send the AT command, MARK (which will be mentioned below), then assign the Parcel member MP within the RilRequest class, and then send it out. The value assigned to MP is the value we need to send to the lower level. For example, to pass an array down, we usually write the length first, and then write the members in turn. =============================================================================================== The next step is the addition of the underlying layer. 1. Hardware/ril/include/telephony/ril.h In this file, add a macro that identifies the AT command you are dealing with, that is, the MARK mentioned above, and be careful not to conflict with other macros. Note: the MARK here must be defined at the back, or it will cause unnecessar