RTM充模分析控制体积法的求解方法.pdf

3 No3 32 2006 9 FIBER COM OSITES Sep, 2006 RTM 1, 2 1 江顺亮 , 万志国 ( 1 , 330029) ( 2 , 330029) RTM , , , , , , RTM; ; PCG; Solving Approach for Control- Volume Method of RTM Mold Filling Analysis 1, 2 1 JIANG Shun- liang , WAN Zhi- guo ( 1 Dept of Computer Science and T echnology, Nanchang University, Nanchang, 330029) ( 2 Dept of Chem ical Engineering, Nanchang University, Nanch ang, 330029) ABSTRACT The control - volume method of Resin T ransf er Molding analysis m ay generate asymm etric matrix f or som e meshes To m ake full use of the available solving methods of symmertric matrix, an approach is proposed in this paper Since the asymmet ric property of the equation m atrix is w eak and the filling process is gradual, the asymmetric part can be put in the right side of the equation and the right side of the equ ation can be updated only w hen the f illed nodes are ch anged The Pre- conditioner Conjugate Gradient solver is used to calculate two examples The result show s th at the proposed solving approach is effective and su itable for the mold filling analysis of the three dimensional meshes KEYWORDS Resin T ransf er Molding; Control volum e method; PCG; Asymm etric method [ 3] [ 7] 1 , LU RTM , RTM , [ 11] 2 , , RTM [ 1~ 11]