ansysworkbench–simulation-snscourseware.pptVIP

March 29, 2005 Inventory #002215 1-* … Navigating Between Modules The topmost tabs allow users to navigate between opened Workbench modules March 29, 2005 Inventory #002215 1-* … Exiting Workbench When exiting Workbench, the user will be prompted to save any files that have changed since the last save In this example on the left, the highlighted Workbench database, DesignXplorer study, and DesignModeler geometry have changed since the last save, so the user is prompted to save all or none of the highlighted items. If individual files are to be saved, this can be done within the appropriate Workbench module. Changes to CAD geometry are not controlled within Workbench but through the CAD software. * * AWE= ANSYS Workbench Environment Note: depends on configured license options and software of course. March 29, 2005 Inventory #002215 1-* ANSYS Workbench – Simulation Training Manual Introduction Introduction Chapter One March 29, 2005 Inventory #002215 1-* Welcome! Welcome to the ANSYS Workbench Simulation introductory training course! This training course covers the basics of using Simulation in performing structural and thermal analyses. It is intended for all new or occasional Simulation users, regardless of the CAD software used. Although some aspects of interfacing with ANSYS will be covered, this course is not intended for users wishing to work primarily in the traditional ANSYS environment. Those users should consider taking Introduction to ANSYS Parts 1 and 2 Training courses. This course covers the Simulation module of ANSYS Workbench. DesignModeler, DesignXplorer, FE Modeler, and CFX-Mesh modules of ANSYS Workbench are covered in separate classes. March 29, 2005 Inventory #002215 1-* Course Objectives To teach the basics of using Simulation in the following areas: General understanding of the user interface, as related to geometry import, meshing, application of loads and supports, and postprocessing Procedure for performing FEA simulations, including line