奥尼q721（Hybrid q721）.docVIP

奥尼q721（Hybrid q721） A charge: This machine is built-in rechargeable lithium battery, the initial use of this machine, please charge first, MINI DV can be charged by the following way: 1, connect the computer to charge, use the USB data cable connected to the computer, can be charged 2, use the charger, USB data line and the charger connected to the charger plug electrical outlet, charging. When charging, green light and red light is also bright, both in the stationary state. Note: when the battery is low, the product will directly enter the state of protection, can not boot. At this time, please charge on this machine. Three times before using this product, please recharge the battery products, and keep the charge for 12 hours, the battery reaches the maximum efficiency. When it comes to plug the charger, the blue indicator light, red indicator light flashes slowly; when the charge for 3~4 hours, the battery is full, the red light Two, boot / sound camera Please confirm the T-F card inserted in! Then the ON/OFF key to move to the position of ON, short press M button, the red indicator light, enter the voice video standby mode, namely the product in the boot, will default to the voice recording mode directly. When the sound is above 60 dB, this product will start the automatic camera, red light lit, the blue indicator light flashes slowly, to start the camera, each video recording the shortest time is 120 seconds, 120 seconds when continued higher than 60 decibels, the product will continue recording; when there is no higher than 60 DB 120 seconds after the sound of this product when in standby state. Video resolution: 640*480, 29~30fps/S. Note: please make sure the a. T-flash has been inserted in this product (Micro SD) card, if not the card, this product will be in 15 seconds after the automatic shutdown, as in the pre boot without a T-F card, easy to cause the phenomenon of death. B. T-flash (Micro SD) the maximum capacity of 16G C. file preservation needs some ti