安装调试变频器应注意的几个重要问题（Several important problems should be paid attention to when installing and debugging converter）.docVIP

安装调试变频器应注意的几个重要问题（Several important problems should be paid attention to when installing and debugging converter） Converter is the use of power semiconductor devices will be the role of on-off frequency power conversion to another frequency power control device. We now use the converter mainly adopts the AC-DC-AC mode (VVVF inverter or variable frequency vector control), the first AC power into DC power supply through the rectifier, then the AC power into DC power supply frequency and voltage can be controlled by the supply of electric motive. The inverter circuit consists of rectifier, intermediate DC link inverter and control of 4 parts. Part of three-phase bridge rectifier is not controlled rectifier, inverter part of three-phase bridge inverter IGBT and PWM output waveform, the DC link for the filtering, storage and buffer DC reactive power. Inverter selection: The selection of frequency converter to determine the following: 1) the use of variable frequency; constant voltage control or constant current control. 2) inverter type of load such as the vane pump or pump; volume, pay special attention to load the performance curve the performance curve determines the ways and means of application. 3) the frequency converter and load matching; I. voltage matching; inverter rated voltage and rated voltage of the load. II. current matching; ordinary centrifugal pump, rated current rated current of the inverter and the motor. For special load such as deep water pump and so on need to refer to the electrical performance parameters to determine the maximum current inverter current and overload. III. torque matching; in this case the constant torque load or deceleration device that may occur when. 4) the use of high-speed motor drive inverter, due to the high-speed motoranti small harmonic increase value resulting in increased output current. Therefore the inverter for high-speed motor selection, selection of its capacity to be slightly larger than ordinary motor. 5) if you