海德堡故障处理2（Heidelberg troubleshooting 2）.docVIP

海德堡故障处理2（Heidelberg troubleshooting 2） Print data center Troubleshooting of HD102V four-color offset press in Heidelberg Troubleshooting example of HD102V four-color offset press in Heidelberg (1) Fault 1: brake failure, starting machine speed Reasons: (1) circuit fault; brake system misalignment (Guo Song); brake device; copper pad; rot. Repair: first, check the brake circuit, troubleshooting; 2. Release the brake, adjust the end cover fastening screws, the end cover clockwise direction Adjust an angle, and then tighten the screws can be tightened; 3. Carefully disassemble the brake, replace the copper pad, if not prepared Pieces can be used 0.3mm thick brass skin or PS version lofting, cutting, drilling substitution, disassembly must be careful, lest dislocation or Bad assembly led to a new fault. Due to limited space, with disassembly and adjustment method is omitted. Fault 2: the host can not run or when good or bad, there is a heating phenomenon, but the transmission is normal The reason: the main circuit or commutator motor fault; the brake imbalance (too tight); the brake maintenance is not good. Too much, the chip gap to fill; 4 reasons, not timely maintenance or other causes of brake heat generation too much, The inner core steel failure deformation, resistance surge, the main stop. Repair: (1) check the circuit, motor, troubleshooting; 2. Loosen the brake cover, tighten the screws, counter clockwise rotation of a certain angle Take apart the brake, clean the parts and assemble them according to the correct steps Sheet and sheet copper. Fault 3: when the main engine is running normally, the point wheel will follow or turn off Reasons: first, the circuit fault or limit switch contact gap is not good; secondly, the inching device, the excitation wire package end face and the driven wheel wheel end The surface assembly clearance is too small, squeezing or plugged with foreign body displacement, dynamic failure due to friction; the dynamic bearing device; If th