电动车常见故障与维修（Common faults and maintenance of electric vehicle）.docVIP

下载本文档

3
0
约1.1万字
约 11页
2017-08-16 发布于河南
举报
版权申诉

电动车常见故障与维修（Common faults and maintenance of electric vehicle）.doc

1、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。。
2、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
3、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。
4、该文档为VIP文档，如果想要下载，成为VIP会员后，下载免费。
5、成为VIP后，下载本文档将扣除1次下载权益。下载后，不支持退款、换文档。如有疑问请联系我们。
6、成为VIP后，您将拥有八大权益，权益包括：VIP文档下载权益、阅读免打扰、文档格式转换、高级专利检索、专属身份标志、高级客服、多端互通、版权登记。
7、VIP文档为合作方或网友上传，每下载1次，网站将根据用户上传文档的质量评分、类型等，对文档贡献者给予高额补贴、流量扶持。如果你也想贡献VIP文档。上传文档

电动车常见故障与维修（Common faults and maintenance of electric vehicle）

电动车常见故障与维修（Common faults and maintenance of electric vehicle） Common faults and maintenance of electric vehicle 1, the meter shows normal, the motor does not turn (1) cause of failure; The brake speed control switch to the judgment of damage damage judgment the motor damage judgment and controller damage (2) troubleshooting Unplug the brake socket (normally open brake handle). For example, when the motor is running, the brake handle shall be replaced by the brake handle. Turn the voltage of the source 5V normal, detect the signal voltage, turn to turn, the signal voltage should be from 0.8 to 4.2V, from low to high. If there is no change in voltage and less than 1V, the switch is turned or the circuit is short circuited. If the voltage is greater than 1V and the change is normal, check the motor Holzer signal (yellow, green and blue lines). If the three-phase Holzer signal line voltage is all 5V, and good contact, then the motor Holzer damage, should replace the motor or motor Holzer components. Third, the motor Holzer signal line is detected, and the motor is rotated slowly by hand. Each phase voltage should change between 0 and 5V. If there is no change in the voltage, the motor is damaged by Holzer, and the motor or motor Holzer component should be replaced. If the voltage of each phase is changed normally and the power supply is normal, the controller is damaged and the controller is replaced. Use multimeter to check the input voltage of controller power supply, the voltage should be greater than 36V (battery sufficient electricity), if there is no voltage, the input line should be checked. Check the controller to turn the power supply voltage (then turn red, black line), the normal voltage is 5 ~ 6V, if no 5V voltage, turn off voltage socket, recovery of 5V, may be Holzer motor short circuit, if there is no 5V voltage for controller failure, should replace the controller. The first check to the governor and Holzer at the beginning of motor has no short circuit,