电焊工考试题2（The examination of 2 welders）.docVIP

电焊工考试题2（The examination of 2 welders） Welder examination Yes no questions. (is draw tick, non *.) Carbon dioxide welding will produce a lot of smoke and CO, easy to rust, so the workplace needs proper ventilation. () The wind speed of the workplace should be less than 1.5m/s. () The cylinder can be placed in direct sunlight or near the high temperature heat sources. () A power switch can be connected to 2 welding machine. () Welding cable is too long, the cable can be coiled into excess volume. () Install carbon dioxide valve ah, the operator should stand on the side of the bottle. () Carbon dioxide welding parameters are: arc voltage, welding speed and wire diameter, wire length, gas flow. () Carbon dioxide welding if the welding current is too small droplet thick, melt depth, arc stability. () When the welding speed increased, the weld width decreases with the thickness of. () The welding speed is reduced, prone to welding deformation increases, the blowhole undercut and incomplete penetration phenomenon. () The arc voltage is too low, the arc combustion instability. () The arc voltage is too high, the arc stretched, there will be large granular spatter. () The gas flow rate, arc instability, the surface will become dark brown, with dense mesh holes. () The gas flow is too large, eddy current, light brown weld surface. () In the normal welding condition, the welding current is below 200A, the carbon dioxide gas flow of 10 - 15L/min. () The distance between the nozzle and the workpiece size, does not affect the weld quality. () In the process of welding, the distance between the nozzle and the workpiece should be maintained at 5mm. () There is no direct relationship between the size of the welding torch inclination of weld appearance and forming defects. () The arc, if cannot maintain the quasi normal distance between the nozzle and the welding, it is very easy to produce defects. () In the ending, after welding, the release of gun switch, while keeping the gun kni