耳机端口的emi设计经验 电磁兼容(emc)设计与整改方案（EMI design experience of headphone port, electromagnetic compatibility (EMC) design and rectification scheme）.docVIP

耳机端口的emi设计经验 电磁兼容(emc)设计与整改方案（EMI design experience of headphone port, electromagnetic compatibility (EMC) design and rectification scheme） EMI design experience | electromagnetic compatibility (EMC) headset port design and Solutions - grounding, shielding, filtering net - Electromagnetic Compatibility (EMC) - Home - Powered by PHPWind certification See the full version: EMI headset port design experience can be Electromagnetic compatibility (EMC) - Certified Network Home - electromagnetic compatibility (EMC) design and Solutions - grounding, shielding, filtering, EMI design experience [print this page] headset port Login registration reply: Theme - - Theme Bovey2008-07-14 13:15 EMI headset port design experience Of course, I did not write out. I start to talk The recently discovered headset port no clue to the rectification, especially from the ground in coupling With magnetic inductance, ah, feel the impact is not great. Comparison of permeability which big brother on the study To discuss the general idea and use the size of the rectification rectification Googf2008-07-15 14:52 General attention is not a digital signal through the digital part and the analog part of the dividing line, can also be in the signal line and filter capacitor, we usually use 220pF, when debugging can be increased to 0.01uF, but the impact on the signal quality of great need to test. Allenearl2008-07-15 22:27 For the audio circuit, personal experience as follows: 1) power supply must filter 2) audio chip analog and digital parts must be separated 3) simulation part must in each layer are hollowed out, the other layer of digital signal to avoid in hollow area 4) analog and digital can use a capacitor or 0 ohm resistor connected to the.Beads effect is not very good. 5) HP, MIC output port to avoid using the capacitor to filter. Wandering prodigal 2008-07-16 14:24 I also feel sometimes not good rectification headset circuit Bovey2008-07-28 13:50 Yesterday I met this problem, the solutio