超声波测厚仪失真维修方法（The distortion of the maintenance method of ultrasonic thickness gauge）.docVIP

超声波测厚仪失真维修方法（The distortion of the maintenance method of ultrasonic thickness gauge） Distortion maintenance method of ultrasonic thickness gauge 2011-10-26 9:09:12 Shenzhen oyea Electronics Co. Ltd 6 When the ultrasonic thickness measurement in practical application, especially in monitoring service equipment, if the distortion value, deviation from the actual thickness of the phenomenon caused by pipeline (equipment) problems, based on the error data to replace the pipe, causing a lot of waste materials. According to the use of ultrasonic thickness gauge in recent years, the distortion of ultrasonic thickness gauge and the points for attention in use are analyzed. 1, no indication or indication of display flashing instability reasons: this phenomenon often appears in the field of equipment and pipeline detection, through the analysis of a large number of phenomena and data, summed up ultrasonic thickness meter distortion and use the matters needing attention are as follows: (1) the surface roughness of the workpiece is too large, so that the coupling effect between the probe and the contact surface is poor, the reflected echo is low, and even the echo signal can not be received. Most of the equipments and pipes are corroded on the surface, and the coupling effect is very poor. (2) the radius of curvature of workpiece is too small, especially when measuring the thickness of small-diameter tube, because the surface of probe is plane, contact or contact with the surface of surface, the transmission of sound intensity is low (coupling is bad). (3) the detection surface is not parallel to the bottom, and the acoustic wave encounters scattering at the bottom, so the probe can not accept the wave signal. (4) austenitic steel castings, due to uneven or coarse grain, the ultrasonic attenuation have serious scattering which passes scattered along the path of ultrasonic propagation in complex, may make the echo annihilation, which shows. (5) the contact surface of probe has c