车床维修（Lathe maintenance）.docVIP

车床维修（Lathe maintenance） CNC machine tools maintain a wide range of CNC machine tools, all types of CNC machine tools because of its function, structure and system of different, each has its own characteristics. The maintenance of the content and rules of maintenance also have their own characteristics, which should be according to the actual usage, types and types of machine tool, and refer to the machine instructions and requirements, develop and establish the necessary periodic maintenance system, grading. Here are some common and common daily maintenance points. Strictly abide by operating procedures and routine maintenance system CNC equipment operators should strictly abide by the operating procedures and routine maintenance system, and the technical and professional quality of the operators is an important factor affecting the frequency of failure. When the machine tool fails, the operator should pay attention to retain the scene, and to the maintenance staff to explain the situation before and after the fault, in order to facilitate the analysis, diagnosis of the cause of the failure, timely elimination. Prevent dirt and dirt from entering the inside of the numerical control device In a machine shop in the air will generally have oil mist, dust and metal powder, once they fall the circuit board or electronic devices within the NC system, easily lead to decreased insulation resistance between components, components and even lead to the damage of circuit board, each cooling fan should check whether the normal numerical control cabinet. Check the air duct filter every six months or every quarter. If the dust accumulated on the filter line is too many and not cleaned in time, the temperature in the numerical control cabinet will be too high. In the general NC system, the CMOS RAM memory device has a rechargeable battery maintenance circuit to ensure that the contents of the memory can be maintained during the system out of power. In general, even if it has not ex