超级电容应用方案总章(史上最详尽版).pptVIP

医疗 便携电源超级电容器可以作为便携式除颤器的放电电容。 由电容所提供的大脉冲能量约为200-360J，单方向通过电极的全部电流加到病人身上。 发达国家的一些公共场合开始采用便携式除颤器，这样可以尽早地挽救生命。 其中的储能电容器以采用超级电容器为最佳方案，如400J储能仅需25F即可，即使按100F计算，其体积也仅仅为Φ25*45mm。 由于超级电容器的电压很低，可以使用超级电容模组或用功率变换器将电压提高到需要的水平 。 PaceMaker 心脏起搏器, 用超级电容加小马达充电,永久不用更换电池. Energy Harvesting Powercast RF Energy Harvesting Module This wireless power module combines Powercasts RF energy-harvesting technology with a supercapacitor to create a perpetual, battery-free power source for the wireless sensors commonly used in security, environmental and condition-monitoring systems. The module integrates a power receiving antenna, a Powercast Powerharvester to convert the radio waves into low DC power and a supercapacitor. The supercapacitor stores the harvested energy and provides peak transmission power to a wireless sensor/transmitter board such as the Texas Instruments eZ430-RF2500T. Perpetuums PMG17 vibration energy-harvesting micro-generator, together with a supercapacitor, allow wireless sensor system manufacturers to design battery-free condition monitoring systems that collect and report data on machinery for improved asset management. The PMG17 microgenerator converts unused mechanical vibration into a low but steady source of electrical energy. The supercapacitor then stores the energy and delivers the peak power needed to transmit sensor condition data over wireless networks such as IEEE 802.15.4 (Zigbee) and 802.11 (WLAN). Together they can power wireless sensor nodes indefinitely. Energy harvesting is the process by which energy is derived from external sources (e.g., solar power, thermal energy, wind energy, salinity gradients, and kinetic energy), captured, and stored. Energy harvesters currently do not produce sufficient energy to perform mechanical work, but instead provide very small amount of power for powering low-energy electronics. + 安装于电动自行车上 与24V铅酸电池并联使用 10 只2.7V 220F超级电容最高电压27V 重量非常轻: 38克/电容 冷起动: -40oC 快速充电: 2分钟内 脚踏和滑行能量回收效率为90%. 电池只有30%. 延长电池寿命达一倍, 环保 超级电容: 充放电寿命为50