厂用电基础问答题（Power plant basic questions）.docVIP

厂用电基础问答题（Power plant basic questions） Basic questions of power supply for power plants What are the general rules for the operation of the 1. power system? The operating regulations of the auxiliary power system are as follows: (1) the switching operation and the mode of operation of the factory system shall be changed according to the order of the value, the value of the monitor, and the relevant personnel concerned (2) in addition to emergency operations and accidents, all normal operations shall be filled out in accordance with the provisions of the operating order and recitation system (3) the switching of the factory system should be avoided during peak load or shift operation. No shift should be taken during operation (4) newly installed or carried out factory systems with the possibility of changing phase operation, the phase sequence shall be checked before power and parallel switching, and the phase is correct (5) before switching the power supply of the factory system, we must understand the connection mode between the two sides of the power supply system. If the ring network is running, it should be switched in parallel. If the system is open and the system is not clear in the event of an accident, the switch shall not be tied and switched (6) the switching operation takes into account the possibility of overloading the circuit and the transformer, whether the operation system is reliable and the accident is convenient (7) during switch pull and close operation, the instrument change, indicator light and relevant signals should be checked to verify the correctness of the switch action 2. what happens when the power supply is operated by the high voltage plant? How to deal with it? (1) phenomenon: A. alarm sounds, work power switch trip; B. operating power supply current and power meter indicating possible shocks, switching off to zero after tripping; C.0.5 seconds and 9 seconds low voltage protection may act; D. low voltage power supply for work and power