33-《机械设计基础》试题（33- mechanical design foundation examination questions）.doc

下载文档 降价啦

7
0
约1万字
约 11页
2017-08-17 发布于河南
举报
版权申诉
保障服务

33-《机械设计基础》试题（33- mechanical design foundation examination questions）.doc

1、本文档共11页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

33-《机械设计基础》试题（33- mechanical design foundation examination questions）

33-《机械设计基础》试题（33- mechanical design foundation examination questions） Mechanical design foundation examination questions First, fill in the blanks (1 points per space, 30 points) The design principle of 1. belt drive is to assure the belt and have certain. 2. the key to prevent thread looseness is to prevent it. 3. the lubrication effect of the sliding bearing is to reduce and increase the oil groove in the bush. 4. the inner ring of the rolling bearing and the neck of the shaft shall be matched with each other, and the outer ring and the hole of the seat shall be matched with each other. The diameter of the 5. radial sliding bearing is doubled, the ratio of the length to diameter ratio is constant, and the load is constant, and the axial pressure is strong, and the P is the original Times. 6. when designing a pair of gear for reducing the soft tooth surface, starting from the requirement of equal strength, the hardness of the big and small gears should be chosen so that the gear hardness is higher. 7. in a hinged four bar mechanism, the minimum length of the double crank mechanism is the sum of the length of the longest rod and the sum of the remaining two rods. 8. flat key work, rely on the transmission torque. In the 9. chain drive, the number of links is usually taken while the number of chain teeth is often used. 10. under the same conditions, the friction produced by the V belt drive is much greater than that of the flat belt transmission because the force on the contact surface of the V belt is greater than that of the flat belt. 11., when the two axis, you can use the worm drive. 12., from reducing stress concentration considerations, the axis of the flat key keyway milling with better processing. 13. according to the bearing type of the axle, it can be divided into the rotating shaft which is received and transmitted Only the transmission shaft, as well as the non passing mandrel. 14. sprocket speed, pitch, tooth number, the chain transmission of the greate