pkpm系列新规范应用指南——短肢剪力墙_祝耀林（PKPM series of new standard application guide - short shear wall _ Zhu Yaolin）.doc

pkpm系列新规范应用指南——短肢剪力墙_祝耀林（PKPM series of new standard application guide - short shear wall _ Zhu Yaolin） Guide for the application of PKPM series of new specification of short pier shear wall _ to Yaolin Baidu space | Baidu home page | Yaolin Yaolin blog homepage to login to the album | personal files | friends see article PKPM series new specifications Application Guide -- short leg shear wall 2008-07-03 19:33 specification: The 7.1.2 stipulates that the structure of high-rise buildings should not adopt all short leg shear walls. The short leg shear wall should be arranged as a cylinder (or a general shear wall) for a long time to form a shear wall structure with short pier shear wall and cylinder resisting the horizontal force, and comply with the following provisions: 1. maximum use height should be lower than table 4.2.2-1, 7, 8 degrees of seismic design, chalk should not be greater than 100m and 60m. In 2. seismic design, the seismic overturning moment at the bottom of the first vibration mode of the cylinder and the general shear wall should be no less than 50% of the total overturning moment of the total bottom of the structure. In 3. seismic design, the seismic grade of short limb shear wall is higher than that of shear wall established by table 4.8.2. 4. in seismic design, the axial compression ratio of the short pier shear wall is 1, 2 and 3 respectively, and should be no more than 0.5, 0.6, 0.7; the short pier shear wall with no flange or end column, the axial compression ratio limit is correspondingly reduced by 0.1. 5. seismic design, in addition to the bottom strengthening parts according to the high gauge 7.2.10 adjustment shear design, the other layers of short leg shear wall design value, 1, 2, respectively, multiplied by the amplification factor 1.4 and 1.2. 6., seismic design, short shear wall section of all longitudinal reinforcement ratio, the bottom reinforcement parts should be less than 1.2%, other parts should be less than 1%. 7. the thicknes