wagyc-2008(2008b)隔离开关触头压力仪使用说明书（Wagyc-2008 (2008b) isolation switch contact pressure gauge instructions）.docVIP

wagyc-2008(2008b)隔离开关触头压力仪使用说明书（Wagyc-2008 (2008b) isolation switch contact pressure gauge instructions） 1. overview The isolation switch is the high voltage switch equipment in power system using the most widely application range of the maximum amount. Because of the outdoor isolation switch is only completely exposed by environmental climatic conditions influence the most direct and most serious electrical equipment, in the atmospheric environment, its operating conditions are poor, prone to failure of mechanical or electrical. Especially the finger contact part is easy to be affected by rain, dust and harmful gas invasion, resulting in poor contact caused fever, provide the spring finger touch pressure because of the heating and annealing for reducing the pressure, this leads to finger finger burn eventually form a vicious spiral heating accident. In maintenance often only pay attention to change of failure and fracture of the spring, and spring to reduce those pressure cannot be judged and changed, so again in the operation, each contact current distribution will vary because of the pressure, the greater the difference between the current distribution is not uniform, long-term operation occurs after the bad contact of overheating. Fever finger will be a vicious spiral, finger contact will not spread over the entire poor contacts. At the same time, there are a lot of isolation switch contact pressure can be adjusted, if in the maintenance of adjustment when the pressure is not enough or each finger to adjust the pressure difference will also lead to the above phenomenon. Most of the current maintenance personnel criterion of conductive part is to measure the quality of contact circuit resistance, that the loop resistance in the acceptable range of repair work can be completed conductive parts. In fact, given the loop resistance in the product specification is the value of the entire electric circuit, comprising a contact part of the bulk resistance and contact re