一注注意事项-注意（A note - note）.docVIP

一注注意事项-注意（A note - note） The following is the final summary of the legion of mine. 1. concrete structure (1) if there are independent beams, uniform load and concentrated load, the proportion of cases that support the calculation of shear force (75%). In the calculation of the bearing capacity of shear may apply with the formula of shear span ratio. (2) the seismic calculation calculation of seismic influence coefficient, to distinguish between the structure of the material is mixed concrete, or steel structure, different damping ratio, apply formula is also different. (3) calculated by the net shear span, bending by calculating the span, can not be confused. (4) axial tension and small eccentric tension members, reinforced design tensile strength of not more than 300MPa. (5) torsion member, general shear coefficient of the bearing capacity constraints reduce the torsion torsion member, pay attention to value. (6) the most easy to forget about the seismic adjustment coefficient, it is easy to forget!!! (7) the load combination, when the constant load is beneficial to the carrying capacity of the structure, partial coefficient is 1; when the live load is beneficial to the carrying capacity of the structure, subentry coefficient of 0. (8) to calculate the column stirrup ratio, concrete if less than C35, according to C35. (9) to see the topic is the design value and standard value. (10) the calculation of cast-in-place reinforced concrete axial compression and eccentric compression members, such as the cross section of the long side or the diameter of less than 300mm, while in the concrete strength design value should be multiplied by the coefficient 0.8; when the quality of components (such as concrete forming, cross section and axis size etc.) is guaranteed, but not affected by this restriction. (11) the structural steel beams, each side of the vertical reinforcement (not including the upper and lower beam reinforcement and erect steel) 0.1% of the cross-sectional ar