中石北京 混凝土 第二阶段在线作业（In the second stage of Beijing stone concrete online homework）.doc

中石北京 混凝土 第二阶段在线作业（In the second stage of Beijing stone concrete online homework） Assignment The first question in the beam, we will stirrups and bent bars are collectively referred to as Your answer: B Subject score: 0.5 Score: 0.5 Remarks: stirrups and bent bars are collectively referred to as abdominal tendons (see teaching material, page eighty-seventh) Second, when the shear span ratio is greater than 3, what kind of damage usually occurs in the shear member without the abdominal reinforcement? Your answer: A Subject score: 0.5 Score: 0.5 Remarks: at this point the shear is mainly transmitted by tensile stress (see teaching material, page ninetieth) The third question is which of the following structures are specified for the flexural resistance of a continuous beam Your answer: A Subject score: 0.5 Score: 0.5 Remarks: bending steel bars can meet the requirements of flexural capacity of oblique section (see teaching material, page 121st) The fourth question is to increase the amount of stirrup used, which can no longer improve the carrying capacity of the following types of beams Your answer: C Subject score: 0.5 Score: 0.5 Remarks: the compressive failure mainly depends on the compressive strength of concrete In the fifth section, the relation between the shear capacity of the oblique section of the beam without the stirrups and the shear failure under the condition of compression shear failure, diagonal compression failure and oblique tensile failure is Your answer: A Subject score: 0.5 Score: 0.5 Remarks: both oblique and inclined tension are brittle failure, and shear pressure damage is between the two (see teaching material ninety-first pages) The relationship between shear capacity and shear span ratio of diagonal section of sixth beams without stirrups is Your answer: D Subject score: 0.5 Score: 0.5 Note: when the shear span ratio is greater than 1, the shear span ratio increases (see textbook ninety-first) Seventh, the calculation of the shear strength o