中级理论模拟（Intermediate theory simulation）.doc

中级理论模拟（Intermediate theory simulation） Paperless examination, experience, mark, answer, contrast A total of 100 questions (Note: the red marker topic for your mistakes. ) 1, metallurgical safety production situation is generally stable, but the situation is still grim, major accidents still abound. Correct answer: your answer: tick tick 2, small section slab with better mechanical shear, is conducive to reducing metal loss. Correct answer: your answer: tick tick 3, automatic stripping lead ingot should not be notified, labor contractor, pull down speed. Correct answer: put your answer: * 4. The material of the crystallizer mainly refers to the material used in the mold wall copper plate. Correct answer: your answer: tick tick There are two kinds, 5 dummy bar loading mode and type and loading type. Correct answer: your answer: tick tick 6. The main function of the ingot head is to block the top of the mold before casting, so that the molten steel has enough time to solidify into the billet in the mold. Correct answer: * your answer: B. 7. The size of the ingot head varies with the size of the slab. The thickness is generally smaller than that of the mold. The width of 5mm is smaller than that of the mold, 10mm to 20mm. Correct answer: your answer: tick tick 8 longitudinal cracks are the inhomogeneity of the thickness of the primary shell derived from the meniscus area of the mold. Correct answer: put your answer: * 9, the segregation degree is less than 1, which is negative segregation. Correct answer: your answer: tick tick 10, when the slab flame cleaning gun occurs tempering, it should turn off the gas switch quickly, then turn off the oxygen switch. Correct answer: put your answer: * 11, the metal yield of flame cutting decreased by 0.5% to 1%. Correct answer: put your answer: * 12, billet casting off side is the shell in the two cold zone uneven cooling caused. Correct answer: * your answer: B. 13 、 internal mixing type cutting, nozzle cutting, small kerf. Corre