主板（A main board）.docVIP

主板（A main board） As a beginner, to really de novo assembly your computer is not easy, you may know where CPU should be inserted, the memory should be inserted anywhere, but encountered a row of complex jumpers, many beginners do not know how to start. Do you still remember the first time you meet with computer, JS CPU, memory, graphics on the motherboard, and then pulled his keys from his pocket (or just find screws) on the motherboard on the edge of a touch on the computer running up the scene? Are you surprised? (when I first saw it, I was surprised.)! In the face of a new motherboard, JS always does not need to see any instructions, you can in 1 or 2 minutes, the motherboard will be closely connected to the jumper, is not that he is a master? Well, after reading todays article, you will think it is not worth mentioning, and as long as you remember a little bit, you can completely remember, to do not look at the instructions, to get all the secrets of the motherboard jumper. First of all, lets correct a conceptual problem. In fact, the rows of pins on the main board need not be called jumpers Because they simply do not reach the function of jumpers. The jumper is two / three pin, there is a small jumper risk that should be called jumper, it can play the hardware change settings and frequency effect; those with the chassis connection pins do not play this role So, in fact, they should be called panel connecting pins, but since they are not very different from the Jumpers, we often call them jumpers. As to who in the end, the first tube panel connection pin called jumper of people, I believe that no one can be sure. However, since it is so called, and everyone is used to it, we will not pursue these, so in this article, we tentatively call the panel connection pin called jumper. To make it easier to understand, lets start with the connection line in the case. In general, the connection line in the box uses text to mark each group of lines, but how to recognize these