打印机加墨水（Printer ink）.docVIP

打印机加墨水（Printer ink） Ink refilling method: 1, the upper part of the cartridge label torn off, saw five small volume below; 2, distinguish color, there is a hole for red, two holes for the blue, two holes for yellow (toothpicks can be inserted into the small hole to distinguish color); 3, under the nozzle pad a good point, do not litter paper, so as to prevent ink from the nozzle string color; If it is a slight string of colors, more than a few blocks of color can be resolved (for the nozzle part of the string color can be in accordance with this Law). 4, put the needle into the hole for injecting, into the amount of ink (usually each color can be 2ml, not too much) 5. Clean the small holes and label them. Black ink cartridge with the same method of color ink cartridges, just do not know colour, 5 holes to choose any one of them. HP ink cartridge (816\817) ink after the counter clearing method: 1, after filling the ink, use a small piece of transparent glue to stick to the first point in the second column of the left (the contacts face itself, the most on the first point) loading, after the completion of the self-test, may prompt the cartridge error, and then take it out. 2., with another transparent adhesive affixed to the right of the 3 points (HP816 is 34, 35, 36||HP817 is 27, 28, 33), loading, and then self-test, prompt the cartridge error, and then take it out 3. take it out, tear off two transparent glue and load it. Tips: note that the following will need to add ink after the tape in clear paste after must deal with contact, the residual tape must be cleaned before the installation, this method does not limit the number of measurement chip will return to the initial state, and is suitable for most HP cartridges (e contact arrangement), you can rest assured that the use of the same. Matters needing attention： 817 the primary colors contained in three color cartridges: cyan (sky blue), product (Zi Hong), yellow (Ming Huang). The ink cartridge should not be too mu