操作简便方式（Simple operation mode）.docVIP

操作简便方式（Simple operation mode） If you feel the next step is to go wrong, then quickly first store!! 3. to establish a tunnel model, some techniques of simulating the excavation 1) the definition of material properties, the tunnel rock excavation and part of the rock mass are defined different material numbers (although the material properties of them are the same), the purpose of doing so is to do the back of the rock mass in the excavation when choosing the tunnel excavation to facilitate. Such as: rock tunnel attribute MP, EX, 1,1.3E9; MP, PRXY, MP, 1,0.3; DENS, 12300; the rock property of MP, part of EX, 2,1.3E9; MP, PRXY, MP, 2,0.3; DENS, 22300; the red number is the number of elements and attributes. Behind the excavation, through the ESEL, S, MAT, 2, to show part of the excavation of rock mass, thus greatly facilitate the selection of rock excavation. 2) defined material properties, geometry model, meshing and loading constraints, if the definition of sprayed concrete material constitutive model No. 3, you can use the ESEL, S, MAT, 3, shotcrete command, ekill all, kill the selected all sprayed concrete. This is the time to start solving the initial stress. 3) method to select a certain unit. When the excavation, often select unit, can be operated by the utilityselectentities, the select entities pop-up dialog box, the first line contains Nodes, elements, Volumes, Areas, lines, keypoints , the choice of a type that will choose the element type. In the excavation of the tunnel, first with the esel command to display the elements of rock tunnel (with the mouse click, then scroll to see) utilityselectentities, select the elements in the first line of the pop-up dialog box, select the second line By Num/Pick, and then select unselect (not choose to display those elements), box (box) without excavation the last remaining elements, that part shall be excavated, with ekill all command to kill the current display elements, namely the excavation. Repeat the above operati