预制桩（Precast pile）.docVIP

预制桩（Precast pile） Effective pile length: the loads in the specific (or under certain restrictions under the pile top settlement of pile top load), failed to transfer to the pile end, only to a certain position of the pile length, generally refers to the transmission depth is less than the actual length of the pile length. The industry generally refers to the whole section section. Several other long pile concepts are as follows: The design of pile length: general design for a range of values, because the soil area is not uniform, especially bearing layer depth is not the same, the general design have clear requirements for the pile into the bearing layer depth. Drilling and digging piles depend on the soil sample or rock sample of the soil layer of the bearing stratum. The driving and pressing of the pile should be controlled by the penetration depth, the oil pressure, the penetration depth and the penetration rate. Construction pile length: some should calculate the over irrigation section, and some directly use the hole depth or the buried depth to replace the construction pile length and the entrusting party to settle accounts. The length of the pile under the measuring point: the actual length of the pile below the installation position of the sensor. Usually calculated according to the depth of excavation and the depth of excavation treatment. Kong Shen: from the natural ground to the depth of the bored pile or the bottom of the bored pile, the total height of the concrete is generally lower than the hole depth. Embedded depth: the concept of general precast pile or immersed tube pile construction is also calculated from the natural ground. The effective pile length is different according to the force condition, and it is not easy to calculate What you estimate is the budget and final accounts, is that true?: The budget is calculated according to the length of the design pile, and the settlement is calculated according to the length of the pile to be buried. Th