桥博经验（Bridge Experience）.docVIP

桥博经验（Bridge Experience） 0, the output unit is mm Bonet bridge crack, internal force output unit is KN, the moment output unit KN*m stress output unit Mpa 1, from the CAD into the bridge inside the import cross section or model, the coordinates inside the CAD must be the geodetic coordinate system. 2, the overall coordinate system inside the bridge is upward, so when we load the load, if the whole coordinate system is opposite, we must input negative value. 3, from the CAD to bridge the cross section, the cross section into the same layer inside, different areas are distinguished by different colors. 4, bridge use stage, single live load reaction force is not included in the impact coefficient. 5, bridge use stage, live load reaction force has been included in the shear coefficient of 1.2. 6, calculate the distribution coefficient of bridge deck line distance first distance of the beam transverse force for lever method and rigid crossbeam method to the first beam of deck beam line at the middle distance; for the rigid plate girder deck beam to the first principle for the middle left outer end of the cantilever plate distance is used to determine the various effects in live load online mobile location. 7, when the component is a concrete component, the weight factor is input to 1.04. 8, bridge, through the section modified to modify section steel, need to add ordinary steel bar check out, in the section to enter the need to replace the steel bar, you can replace the steel bar. 9. After entering the construction load at the construction stage, the permanent load can be checked by the display content setting in the View menu so that you can see whether the input load position and direction are correct. 10, bridge provides custom cross sections, but after using custom sections, the display and computation are slow and require patience. 11, bridge Bo provide material library definition, suggest that you define before doing unity, otherwise, model copy to other computers,