汽车转向（Automobile steering）.docVIP

汽车转向（Automobile steering） 1. inspection of steering column and steering column (1) check the deformation and damage of the steering column and steering column Repair or repair is not allowed. If deformation or damage is serious, it must be replaced. Check the wear and tear of the steering column bearing, and replace it in severe cases. (2) inspection of cardan joint of steering shaft; As shown in Fig. 1, the radial clearance of the cardan joint in the two directions of the cross shaft 1 is checked by hand, and the bearing 3 of the cardan joint shall be replaced if a gap is found. When removing the cardan joint, remove the bearing 3 first, then remove the cross shaft 1 (do the front and front of the cardan shaft 2 and the drive shaft 4). The assembly, should be the first universal joint 2 and 4 drive shaft alignment of the positive marker, first installed on the cross shaft 1, and vise pressure bearing 3. (3) inspection of the support ring of the steering column Inspection of support ring for steering column of Jetta car. Check the wear and damage of the support ring on the steering column. It should be replaced severely. (4) safety cylindrical pin and rubber sleeve bearing check Santana car safety cylindrical pin and rubber sleeve bearing check. Check the steering column safety pin is damaged, the rubber bushing and polyethylene casing is damaged. Check rubber support ring for aging and damage. Check the spring for damage or stretch loss. 2. steering gear inspection (1) inspection of mechanical steering gear; Check the steering pinion and rack for wear and tear, whether the steering gear housing cracks, and pay attention to the steering gear parts are not allowed to weld or correct, can only be replaced. Also check the bearing and bushing wear and damage, as well as oil seals, dust sleeve wear and aging, and timely replacement. (2) inspect the steering damper Inspection of steering damper for Santana car. As shown in Figure 2, check that the steering damper is leaki