蝶阀知识（Butterfly knowledge）.docVIP

蝶阀知识（Butterfly knowledge） Should pay attention to the design of the valve flow resistance, strength, stiffness and structure were discussed on the valve selection should test Put forward suggestions about temperature, pressure, sealing materials and etc.. 1 Overview Butterfly valve is an important device for water supply and drainage pipeline system, with the development of industry technology, put forward different requirements on the structure and properties of butterfly valve. Therefore, in the design and selection should be according to the working conditions, make a reasonable choice of the type, material and connection form etc.. 2. design The structure of 2.1.1 Close the valve (disc) in the middle of the medium, the design should consider the influence of the convection resistance. Of large diameter butterfly valve plate structure, AWWA C504 (AWWA) regulations, the butterfly plate should not have transverse ribs, the thickness is not greater than 2125 times the diameter of the valve stem. The butterfly plate to meet the water and out of water should be streamlined. The internal screw cannot be projected in the butterfly plate outside, so as not to increase the water area. Butterfly is the production of a foreign company in order to reduce the flow resistance of the butterfly plate made of iron pie, the company will also small butterfly plate is very thin, and the water tube for online butterfly valve in the fully open position when the butterfly board has a guide member is in order to reduce the flow resistance. Our JB/ T 5317121999 standard will flow resistance and flow coefficient of the international standard ISO/ TC 153/ SC1GT 8237 (Table 1) included, this shows that the flow resistance is an important index. 2.1.2 rubber seal Sometimes the use of rubber valve short life, which is related to the quality of rubber and the width of the sealing surface. Seal rubber seal butterfly valve should be used in the manufacture of rubber material quality, in pressing