螺栓强度（Bolt strength）.docVIP

螺栓强度（Bolt strength） Bolts marked 8.8, 10.9, these strength refers to what the strength of the bolt, which is what GB or British standard, the unit is how much?! The number in front of the decimal point represents one percent units of tensile ultimate strength (Mpa). The number after the decimal point is ten times the ratio of the yield limit to the tensile strength limit 8.8 refers to tensile strength (tensile stress), the limit is 800Mpa, the yield limit is 800*8/10, or 640Mpa. 10.9 refers to tensile strength limit of 1000Mpa, yield limit of 900Mpa ----------------------------------------------------------------------------------- Take class 10.9 as an example: 10 represents nominal tensile strength (1000MPa), and 9 represents yield strength ratio (0.9). Others and so on. There are no other grades, and class 12.9 is rare. Grade 8.8 and grade 10.9 use materials include -Q235, Q345 and Q390 steel. The general bolt is expressed with the strength of X.Y, X*100= tensile strength of this bolt, X*100* (Y/10) = yield strength of this bolt (as specified by the mark: yield strength / tensile strength =Y/10) For example, grade 4.8, the tensile strength of the bolt is 400MPa, and the yield strength is 400*8/10=320MPa Strength class 4.8, 6.8, 8.8, 10.9, 12.9 Tensile strength (Newton / mm2) 40060080010001200 Yield strength (Newton / mm2) 3204806409001080 -------------------------- What does bolt strength 4T mean? 7 refers to 7T, is a kind of bolt performance level, slightly lower than the national standard of 8.8, and its nominal strength of 700Mpa, Hardness requirements of about HRC20~28 (HB201 TO 277). In Japan, the standard, South Korea standards are often used, Taiwan also has Use this standard. Of course, there are 4T/6T/8T/9T10T/12T, and sometimes 11T. Among them, 4T/6T/ 8T/9T/10T/11T/12T is equivalent to the national standard 4.8/6.8/8.8/9.8/10.9/11.9/12.9, but in The new national standard (International Standard) has not adopted 11.9 levels of /11T, two grades ----------