西门子_s7-200_plc_60个经典问题及解答(二)（SIEMENS _s7-200_plc_60 classic questions and answers (two)）.docVIP

西门子_s7-200_plc_60个经典问题及解答(二)（SIEMENS _s7-200_plc_60 classic questions and answers (two)） 31: the analog filter has what effect? The analog filter function normally use S7-200 do not have to separately compile user filtering procedures. If a channel selection of analog filter, CPU will be in each scanning cycle before the automatic reading of analog input value, this value is the value of filtered, the average value is set by the sampling number. Set the parameters of analog quantity (sampling number and dead value) for all analog signal input channel. If a channel is not filtering, CPU does not start to read the program scan cycle average filtering value, but only in the user program to access the analog channel, the actual value was read directly. 32: how to set the value of the analog filter dead? The dead time value, defines the range of the calculated average value of analog quantity If the sampling values are in the range of calculating average number of sampling set; if the current sampling value exceeds the dead zone of the upper or lower, the value is immediately adopted as the new value of current, and as the calculated average value and initial value This allows the filter to the analog value of the big change has a fast response. The dead time value is set to 0, said that no dead zone function, all of the values are average, regardless of the value of the big changes. For a quick response to the request, dont put the dead time value is set to 0, and set it as the largest perturbation value can be expected (320 to 32000 of full scale 1%) 33: set the analog filter should pay attention to what? 1) selection of input filter can suppress the fluctuation of analog changes relatively slow 2) input with a smaller number of samples and the deadband will accelerate the speed of response is fast changing analog 3) analog of the fast changing values do not use filter 4) if the transmission of digital signals with analog, or the use of thermal resistance (EM231, RTD)