钢筋混凝土预制桩打桩工艺标准（Standard for piling process of reinforced concrete precast piles）.doc

钢筋混凝土预制桩打桩工艺标准（Standard for piling process of reinforced concrete precast piles） Standard for piling process of reinforced concrete precast pile (203-1996) Range This standard is applicable to the construction of precast reinforced concrete piles in industrial and civil buildings Construction preparation 2.1 materials and main equipment: 2.1.1 precast reinforced concrete pile: specifications and quality must comply with the design requirements and construction specifications, and have the factory certificate. 2.1.2 electrode (with pile): model, performance must comply with the design requirements and the relevant standards, the general use of E4303 brand. 2.1.3 steel (pile used): material, specifications meet the design requirements, should use low carbon steel. 2.1.4 main machines are: diesel pile driver, welding machine, pile cap, and pile driving trolley. Wire rope, wire rope, steel plate or steel and wooden folding ruler and so on. 2.2 operating conditions: 2.2.1 pile axis and elevation have been measured and organized through the pre inspection procedures. The pile shaft and the elevation of the control pile should be set up where the pile is not affected and should be properly protected. 2.2.2 deals with obstacles in the upper air and underground. In the case of the use or safety of adjacent buildings or structures, effective measures shall be taken to deal with the units concerned. According to 2.2.3 released pile axis line, with a wooden peg or a steel screw pile, and lime as an indicator for the injections. 2.2.4 site should be rolled and leveled, and the drainage is smooth, so as to ensure the movement and stability of the pile machine. 2.2.5 test pile. Piles must be tested before construction, with less than 2 pieces of wood. Determine penetration, and verify piling equipment, construction technology and technical measures are appropriate. 2.2.6 shall select and determine the entry and exit routes and piling sequences of the piling machine, formulate cons