钢筋计算公式 欢迎收藏（Reinforcement calculation formula welcome to collect）.doc

钢筋计算公式 欢迎收藏（Reinforcement calculation formula welcome to collect） Formula for reinforcement calculation Common formulas for reinforcement sampling Summary of basic methods of reinforcing steel quantity I. beam (1) frame beam First, the calculation of steel reinforcement 1, the upper through tendons The upper perforated rebar (rib 1 = length on long) through cross span long + two end bearing anchor value 2, end support negative ribs The negative length of end support: the first row is the anchor value of Ln/3 + end support; The second row is Ln/4 end support anchor value 3, lower reinforcement The reinforcement length = span long + about bearing anchor value The above three types of reinforcement are involved in the bearing anchor problem, then summed up the above three types of steel reinforcement anchor judgment problem: Bearing width is greater than or equal to Lae and 0.5Hc + 5D, Max{Lae, 0.5Hc + straight anchor, 5D}. The anchor end bearing steel bar = bearing width less than Lae or less than 0.5Hc + 5D, Max{Lae bending anchor, bearing width - protective layer +15d}. The middle bearing anchor bar = Max{Lae, 0.5Hc5d} 4, lumbar tendon Structure: reinforced structural reinforcement length = span length + 2 * 15d Torsion bars: algorithm with through bars 5, pull the tendons Tensile length = (Liang Kuan 2 * protective layer) + 2 * 11.9d (seismic bending hook value) + 2D Brace root number: if we do not have in the flat cloth reinforcement spacing input method given in the stretch, then stretch the root number (root number /2 = stirrup) * (structural reinforcement root number /2); if the reinforcement reinforcement spacing, reinforcement that root number = length / reinforcement reinforcement spacing. 6, stirrups Stirrup length = (Liang Kuan - 2 * protective layer + beam height -2 * protective layer) *2 + 2 * 11.9d + 8D The number of roots (= stirrup length / spacing zone encryption encryption (+1) * 2 + length / non encrypted area non encrypted area spacing 1) +1 Note: