钢筋预算规则3（Steel budget rule 3）.docVIP

钢筋预算规则3（Steel budget rule 3） Rules for reinforcement (budget) calculation 2009-11-25 rules for steel reinforcement at 10:36 The rules for reinforcement calculation are as follows: In the preparation of the budget, the amount of reinforcement can be temporarily calculated according to the volume of the component (or the horizontal projection area, the outer area, the length of the extension), and the content of the reinforcing steel. At the time of settlement, according to the design requirements, no design shall be calculated according to the following rules. (I) general rules: 1, steel engineering should distinguish cast-in-place component, precast concrete, precast, prestressed component factory, welding mesh and different specifications respectively according to the design of expansion length (expansion length, protective layer, lap length should comply with the specifications by weight tonnes) theory. 2, when calculating the amount of steel reinforcement, the length of the joint shall be calculated according to the specifications. When the beam and plate (including the entire board based) through reinforcement of not more than Phi 8 design overlap, budget book Zanan 8m a double-sided welding joint should be considered, according to the actual length of reinforced adjustment lap number at the end of lap mode according to the construction organization design has been approved to determine. 3, pretensioned member in prestressed and non prestressed reinforcement quantity should be combined according to the design calculation of the length, according to the quota (prestressed beam, large roof panel, F Board Executive Phi 5 outside the quota, the rest were performed in 5 with quota execution). The post tensioned prestressing steel and non prestressed steel bars are calculated respectively, and the length of the reserved steel pipe of the prestressing steel bar according to the design drawing is calculated, and the different anchorage types are calculated according to