如何修耳机（How to repair the headset）.docVIP

如何修耳机（How to repair the headset） The reason of failure is nothing more than, summarize the headset, membrane collapse, membrane cracking, film falling, iron, a voice coil connecting line break, break, headset headset, headset line hard line cracking, broken shell, sound hole blockage, send membrane degradation etc.. Ill talk about the cause of the trouble. 1. film collapse, film cracking, film peeling and iron powder treatment method General headphones have broken sound, noise, bass missing fault, the general consideration may be the cause of the above. First, open the headset for soft shell, set the first set down the soft structure headset, then pointed tweezers tapering tools a little open iron and steel net, until all exposed to film. The hard shell earphone can be made up of a small screwdriver at the joint seam, and then it can be easily opened, and finally the membrane is exposed. Big headset is another matter, but in the film exposed all the headset, to facilitate the operation. Collapse of the membrane, for the collapse of the film failure, tweezers can be used to clamp a small piece of double-sided adhesive, gently place the film collapsed place adhesion. Pay attention to the magnitude of control. When the film is recovered, replace it as it is. Film cracking is unlikely to repair, and even when repaired, the sound quality is impaired. However, there are also successful, sound damage is very light, can be ignored. With the needle dipped in a little 704 glue (also called vulcanized silica gel), painted in the cracks. Dont be too thick to cover the cracks. Then fit the casing. Remember, do not immediately audition, should be placed two days later to try again. Because vulcanized silica gel works slower. Film off, with 704 or fish glue coated a little, can stick to. Pay attention to flat compression. Put it back for a day. Into the iron powder, with cotton swabs dipped in water, iron powder dipped, and then deal with membrane collapse. 2. tone coil disconnect