机房布线（Engine room wiring）.docVIP

机房布线（Engine room wiring） The foundation of computer software and hardware stable operation is good computer room environment. Cabling in the computer room is very important. In terms of ways: Floor: the most common wiring wiring way, should pay attention to Water Leakage, rodents and heat under the floor, also should ensure that in each cabinet below the cut line through hole (including the floor and the corresponding slot). Suspended ceiling wiring: especially suitable for a room where wiring is often required. In this way the ceiling contains a variety of power wiring and cabling, in each cabinet above the cut line through hole corresponding (including floor and trough), of course also should pay attention to Water Leakage, rodents and heat. In terms of content: Power wiring: power supply wiring in the new room decoration, should be based on the whole room layout and the capacity of UPS to arrange, in the planning of each cabinet arrangement and equipment near the corresponding power socket, socket power capacity should be based on the access device to set, and have a certain redundancy, is generally 10A or 15A. Power line diameter should be based on the power socket capacity and leave a certain capacity to buy. Cabling: cabling consists of five coaxial thinnet, cable and telephone cables, wiring should have corresponding cable behind each cabinet, equipment, and should consider the future development needs, should be arranged with various cable braided nylon strapping good. Ground wire: because the new room is of high performance computer and network communication equipment, the ground has strict requirements, but also to eliminate public grounding impedance, preventing capacitive coupling interference, to protect the safety of equipment and personnel, an important measure to ensure stable and reliable operation of the computer system. In the room floor under ground layout signal copper for room all kinds of grounding, weak signal to access the copper line ground