外墙保温做法（Exterior wall insulation practices）.docVIP

外墙保温做法（Exterior wall insulation practices） I. construction preparation: 1. Material preparation: The polystyrene foam board; The special adhesive; The single component polymer mortar; Finally, alkali fiberglass mesh cloth; The plastic expansion bolt; 6, polystyrene foam stick; Water, water. 2, tool preparation: The electric wire cutter or wallpaper knife; The handsaw; The fountain; The 2m, on foot; The ruler; 6, wood; 7, tape; 8 electric mixer; 90, float; 30, Yang Kok minzi; 2, plastic mixing barrel, and coarse paper. Let 2m drag strip 3, technical preparation: Firstly, according to the specific situation of the construction of the wall painting a row block diagram and cloth nail map. Secondly, according to the construction drawings and construction work to develop row block diagram. Two, construction conditions: 1, the construction site should have power, water through the construction conditions, and maintain a clean working environment. 2, the surface environment temperature and the wall temperature of the base wall shall be no less than 5 degrees centigrade The strength is not greater than 5, and proper protective measures should be taken during winter application. 3, surface mortar construction, should avoid direct sunlight. When necessary, build on the scaffold Prevent the cloth from spreading and block the construction wall. 4, during rainy season construction, effective measures should be taken to prevent rain from washing the wall. 5, before construction, must carefully check the grass-roots wall verticality and integrity, and should meet the requirements of the following table: Engineering practice inspection item allowable deviation (mm) inspection method Masonry wall verticality of each layer of 52m drag strip check The 10m 10 theodolite or hanging check 10m 20 The surface roughness of 5 2m by foot and wedge feeler check The 8 storey concrete verticality less than 5m 2m drag strip check 5m 10 The high H/1000 and less than or equal to 25 theodolite or