展鹏门机（Toplus door machine）.doc

展鹏门机（Toplus door machine） 1. electrical wiring instructions 1.1. Electrical wiring diagram (electrical diagram 1) 1.2. Power supply The use of single-phase AC power Ac220v: 5%, 50Hz, 5%; proposed through the melon, c45N, etc., to the gantry power supply. 1.3. Encoder wiring The factory is equipped with encoder connection, and only need to be closely connected with the controller. 1.4. Motor wire At the factory, the motor Equipped with three-phase motor wire, only need to be closely connected with the controller. 1.5. Input / output signal wiring 1.5.1. Enter Input a total of four common power terminals (24V, provided by the gate controller), may be relay contact input, or can be open collector contacts. Each input terminal can be independently defined as any of the following functions, normally open or closed, or optionally defined, but not defined repeatedly. Otherwise, the error is reported. The Hl and H4 correspond to the input terminals 111 and one respectively. 1.5.1.1. Close the door and enter a signal that the host computer sends to the system. The closing signal must be a continuous signal. The signal must be defined, otherwise the error will be reported. For example: Hl = 01 indicates that Hl and 24V are required to close; H1 = 06 indicates that Hl and 24V are required to close. 1.5.1.2 open the door to enter a host computer to the system requirements, the opening signal must be a continuous signal. This signal must be defined, otherwise it will be reported wrong. For example: H2 = 02 indicates that the H2 and 24V pass are required to open the door; H2 = 07 means H2 and 24V break to open the door 1.5.1.3. Slow closing a single input, that is, the usual timeout forcing closed door letters, must be a persistent signal. The signal is required to close at medium speed. A signal is 1.5.1.4. Electric eye door protection signal usually, such as infrared curtain / safety contact plate, to directly use, must be connected to the non open area signal. The signal may b