广日梯gvk.gvb.gvh.gvz.变频调速电梯调试（Wide day ladder gvk.gvb.gvh.gvz. frequency control elevator debugging）.docVIP

广日梯gvk.gvb.gvh.gvz.变频调速电梯调试（Wide day ladder gvk.gvb.gvh.gvz. frequency control elevator debugging） Wide day ladder GVK.GVB.GVH.GVZ. frequency control elevator debugging First of all, on-site electrical wiring inspection. I. overhaul status trial run A car overhaul: 1 check and check whether the setting parameters of frequency converter meet the requirements. 2 in the car, the switch will be placed in the overhaul state. Then do not leave the car in the car, and on the computer control panel operation. 3 at this point, PC machine input point X7 bright, X10 out of the car can be checked by way of trial operation. 4 within the car overhaul uplink, can be 11L14 high station internal command input point short connection. 5 within the car overhaul downlink, available 11L40 with the lowest level station within the instruction input point short B car top overhaul: X7.X10 is not available at this time, you can use car top overhaul trial run. 1. car top overhaul uplink, 11L40 and 21L6 short, [X11 bright] 2. The top of the car is under repair and 11L40 and 21L7 are shorted. [X12 bright]. 3, maintenance operation lift state; when 11L40 and slow or slow down point, the elevator should be closed immediately, [PC, out of Y3. GMJ uplink; SJ uplink or XJ uplink]. At the end After full shutdown, the [Y3 is extinguished; the GMJ is down. Y14 or Y15 `Y12`Y0 light]. The elevator starts immediately, up or down. At this point, observe whether the direction of the elevator is in accordance with the direction of your instruction; if not, change the setting value LF5 of the frequency converter [0/1] until the direction of the elevator is in accordance with the direction of your instruction. At the same time, the direction and to observe the parameters of converter [+ - LF88 and LF89 are the same. If not, it is necessary to change the setting value [on/off] of the frequency converter LF18. Until the two directions are identical. 4. the maintenance status should be opened immediately after the