开关电源1234（Switching power supply 1234）.docVIP

开关电源1234（Switching power supply 1234） General considerations for the design of switching power supplies Switching power supply, design Before designing a switching power supply, the technical requirements of the power supply to be designed should be carefully studied. An example of a communication power module is presented to illustrate the design considerations. The technical specifications for this module are as follows: 1 electrical performance Unless otherwise noted, all parameters are tested and specified at the input voltage of 220V, AC 50Hz, and ambient temperature of 25 degrees 1.1 inputs Voltage: single phase AC rated voltage, RMS 220V + 20% Frequency: frequency range 45-65Hz Current: at full load, enter 220V, less than 8A. At 264V, the impact current is not greater than 18A Efficiency: load by 50% - 100% value in Table 2.1 Power factor: greater than 0.90, load more than 50%, greater than 0.95 Harmonic distortion: meets IEC 555-2 requirements Start delay: output power up to its rated level within 3 seconds of power on Hold time: enter 176V valid value, full load, greater than 10mS 1.2 output Voltage: at full load, the output voltage is set at + 0.2% of Table 1 Current: load current from zero to maximum (see Table 1). Overcurrent protection begi