汽车故障维修（Automobile Trouble Shooting）.docVIP

汽车故障维修（Automobile Trouble Shooting） POLO strong feeling. After the wiper does not stop fault detection Manual car, car owners to reflect the car as long as starting the engine or turn the ignition switch, after the wiper motor will always rotate wiper switch gear is not adjusted Effect。 The wiper motor will stop turning only when the ignition switch is switched off or the wiper is pulled out. After receiving the car for verification, the failure is true as described by the owner. Each control unit fault memory is checked with the VAS5052, and no fault codes are found. The author suspects that the fault is in the circuit control section, wiper switch, or in the on-board network control unit In comparison with the circuit diagram, first of all, after detecting the wiper motor 4 lines and wiper switch and power supply connection: 1 pin brown line, is the negative connecting wire, measuring no problem. Number 2 green / white line, It is drawn from the wiper switch T41/20 and connected to the on-board network control unit (T18a/\5 pin), and there is no problem with the measurement. No. 3, feet, green, purple lines, hills) are drawn from the wiper switch T41/21 and connected to the wiper jet The No. 2 of the water motor in the inside of the left front wheel prevents the problem from being measured. The No. 4 pin is the positive power supply of the wiper motor, which is powered by the SB1 fuse controlled by the X- contact unloading relay, and the measurement is also no problem. Measure the positive and negative of the 1 and 4 pins, and the power supply is normal. The circuit also has no short-circuit or disconnection. Since the intermediate line has not found the cause of the fault, the cause of the trouble is at both ends of the line. Taking into account the wiper motor can run, so decided to first remove the wiper switch. After removing the airbag, remove the steering wheel and pull out the wiper The plug and then turn on the ignition switch and find that the wiper motor