电子科技大学成果(项目)一览表（List of achievements (projects) of University of Electronic Science and technology of China）.docVIP

电子科技大学成果(项目)一览表（List of achievements (projects) of University of Electronic Science and technology of China） List of achievements (projects) of University of Electronic Science and technology of China The number of technical characteristics of quasi (positive) cooperation cooperation unit 1 high specific capacitance of aluminum foil manufacturing and detection technology under 20V voltage, Al2O3-TiO2 high dielectric constant composite dielectric film than the product volume of pure Al2O3 dielectric film and withstanding voltage is increased by more than 25% without the transfer of patent industrialization of LiFePO4/C composite cathode materials and cathode materials LiFePO4/C LiMn2O4 2 electric vehicle power battery Material composition: LiFePO4/C composite cathode material The first discharge capacity is not less than 150mAh/g The first charge discharge efficiency is not less than 90% 2.Li1+xMn2-xMyO4-dFd composite cathode material Specific capacity of first discharge: 100~135 mAh/g The first charge discharge efficiency is not less than 90% (1) technology transfer; (2) transfer of the right of use; (3) technology shares; (4) incorporation of new companies for R D, production and distribution. 3 lithium ion power storage battery The fifth generation of new cathode material LiFePO4 large specific capacity Greater specific power Good safety performance Good cycle performance Good environmental protection performance Abundant resources Very low cost Non-toxic High temperature performance, no (1). Technology transfer (2). The joint development of 4 LTCC stacked microstrip patch antenna F0 = 1268.52MHz = 50MHz; bandwidth; Bobbi in less than 2; characteristic impedance: 50 ohm; circular polarization; polarization: size: less than 40mm * 40MM * 3mm technology transfer 5 large size gadolinium gallium garnet (GGG) single crystal research in diameter 4 inches, length 30cm. (111) crystal orientation, lattice constant 12.383. Cutting and polishing can obtain 3 inch epitaxial