人工成孔灌注桩（Artificial hole filling pile）.docVIP

人工成孔灌注桩（Artificial hole filling pile） Disclosure content: Artificial hole filling pile 1 range The process standard is applicable to the artificial bored piles of clay, silty clay and sand soil with small amount of sand and stone and low water level in the industrial and civil buildings. 2 construction preparation 2.1 materials and main equipment: 2.1.1 cement: 325 ~ 425 ordinary portland cement or slag Portland cement should be adopted. 2.1.2 sand: medium sand or coarse sand, containing less than 5% of the mud. 2.1.3 stone: 0.5 to 3.2cm diameter gravel or gravel; pile concrete can also be used more than 5cm stone particles, and mud content is not greater than 2%. 2.1.4 water: clean water with running water or no harmful substance. 2.1.5 plus early strength agent shall be selected by test, and fly ash admixture shall be determined according to the test room. 2.1.6 reinforcement: the grade and diameter of the reinforcement must comply with the design requirements. There is a factory certificate and a re examination report. 2.1.7 should normally have a winch, Sanmu unit or electric hoist, trolley or dump trucks, pick and shovel, hand shovel, drill, line sinkers, fixed pulley block, a guide pulley group, concrete mixer, bucket, chute, conduit, vibrators, drilling, wire rope, safety rope, thick plate waterproof lamp (low pressure, 36V, 100W), electric welder, ventilation and oxygen supply equipment, lift pump, wooden windlass, activity ladder, safety helmets, safety belts etc.. 2.1.8 template: assembled steel mould, arc tool type steel mould four pieces (or eight pieces) assemble. Fixture, hook and spare parts. Board, wooden side, No. 8 or 12, channel steel, etc.. 2.2 operating conditions: 2.2.1 artificial excavation of pile holes, shaft lining support should be based on the soil characteristics of the region, groundwater distribution, the preparation of practical construction program, the calculation and design of shaft support. 2.2.2 excavation, the site should be com